直流磁控溅射一步法原位制备MgB2超导薄膜

用MgB2靶,控制直流磁控溅射工作在异常辉光放电或弧光放电状态,在SrTiO3衬底上原位一次性得到了MgB2超导薄膜,其起始转变温度为32K,零电阻温度为15K. 关键词： 高温超导体 超导薄膜 磁控溅射 二硼化镁     

双阳极磁控注入枪束流特性的研究

 介绍了用于34GHz基波回旋速调管的双阳极磁控注入枪的结构特点，为了准确分析磁控注入枪的束流特性，建立了阴极表面理论模型，用新编制的程序模拟了电子轨迹。模拟和测量结果显示磁场对磁控注入枪的束流有影响，磁控注入枪的束流也与阴极温度和空间电荷效应有关系。     

磁控溅射技术制备ZnO透光薄膜

采用RF磁控溅射方法,在玻璃衬底上制备了择优取向的ZnO薄膜;通过台阶仪、X射线衍射技术、原子力显微镜和分光光度计分别测量了不同溅射功率条件下淀积的ZnO薄膜厚度(淀积速率)、结晶质量、表面形貌与粗糙度、透光光谱,报道了该薄膜结晶质量、薄膜粗糙度与其在可见光区透光率的关系.     

FeCoB-SiO2磁性纳米颗粒膜的微波电磁特性

采用交替沉积磁控溅射工艺制备了超薄多层的FeCoB SiO2 磁性纳米颗粒膜 .利用x射线衍射仪、扫描探针显微镜、透射电子显微镜分析了薄膜的微结构和形貌特征 .采用振动样品磁强计、四探针法、微波矢量分析仪及谐振腔法测量薄膜试样的磁电性能和微波复磁导率 .重点对SiO2 介质相含量、薄膜微结构对电磁性能产生重要影响的机理做了分析和探讨 .结果表明 :这类FeCoB SiO2 磁性纳米颗粒膜具有良好的软磁性能和高频电磁性能 ,2GHz时的磁导率 μ′高于 70 ,可以应用于高频微磁器件或微波吸收材料的设计     

Formation of p-type ZnO film on InP substrate by phosphor doping

ZnO thin film was initially deposited on InP substrate by radio frequency (rf) magnetron sputtering and the diffusion process was performed using the closed ampoule technique where Zn₃P₂ was used as the dopant source. To verify the junction formation of ZnO thin films, the electrical properties were measured, and the effects of Zn₃P₂ diffusion on ZnO thin films were investigated. It is observed that the electrical property of the film is changed from n-type to p-type by dopant diffusion effect. Based on the results, it is confirmed that ZnO thin films can be a potential candidate for ultraviolet (UV) optical devices.     

氟化类金刚石薄膜的拉曼和红外光谱结构研究

关键词：     

基片温度对坡莫合金薄膜结构和磁电阻的影响

用磁控溅射方法制备了系列坡莫合金Ni80Fe20薄膜。利用X射线衍射、扫描电子显微镜和原子力显徽镜分析了薄膜的结构、晶粒取向、薄膜厚度、截面结构和表面形态。用4点探测技术测量了薄膜的电阻和磁电阻。结果表明：随衬底温度的升高，晶粒明显长大。膜内的缺陷和应力显著减小，而且增强了薄膜晶粒的[111]择优取向。结果表明，薄膜电阻率显著减小，而磁电阻显著增大。     

Influence of silicon on the microstructure and mechanical properties of Zr-Si-N composite films

A series of Zr-Si-N composite films with different Si contents were synthesized in an Ar and N₂ mixture atmosphere by the bi-target reactive magnetron sputtering method. These films’ composition, microstructure and mechanical properties were characterized by energy dispersive spectroscopy, X-ray diffraction, scanning electron microscopy, atomic force microscopy and nanoindentation. Experimental results revealed that after the addition of silicon, Si₃N₄ interfacial phase formed on the surface of ZrN grains and prevented them from growing up. Zr-Si-N composite films were strengthened at low Si content with the hardness and elastic modulus reaching their maximum values of 29.8 and 352 GPa at 6.2 at% Si, respectively. With a further increase of Si content, the crystalline Zr-Si-N films gradually transformed into amorphous, accompanied with a remarkable fall of films’ mechanical properties. This limited enhancement of mechanical properties in the Zr-Si-N films may be due to the low wettability of Si₃N₄ on the surface of ZrN grains.     

Structure and mechanical properties of Al/AlN multilayer with different AlN layer thickness

Nanometer scale Al/AlN multilayers have been prepared by dc magnetron sputtering technique with a columnar target. A set of Al/AlN multilayers with the Al layer thickness of 2.9 nm and the AlN layer thickness variation from 1.13 to 6.81 nm were determined. Low angle X-ray diffraction (LAXRD) was used to analyze the layered structure of multilayers. The phase structure of the coatings was investigated with grazing angle XRD (GAXRD). Mechanical properties of these multilayers were thoroughly studied using a nanoindentation and ball-on-disk micro-tribometer. It was found that the multilayer hardness and reduced modulus showed no strong dependence on the AlN layer thickness. Al2.9 nm/AlN1.13 nm multilayer had more excellent tribological properties than single layers and other proportion multilayers with a lowest friction coefficient of 0.15. And the tribological properties of all the multilayers are superior to the AlN single layer.     

p型未掺杂富锌ZnO薄膜的形成和性能研究

以高纯ZnO为靶材,氩气为溅射气体,利用射频磁控溅射技术在石英衬底上生长出纤锌矿结构的富锌ZnO薄膜.薄膜沿(002)择优取向生长,厚约为1.2μm,呈现电绝缘特性.将溅射的ZnO薄膜在10-3Pa,510~1 000 K的温度范围等温退火1 h,室温Hall测量结果表明ZnO薄膜的导电性能经历了由绝缘—n型—p型—n型半导体的变化.XPS测试表明ZnO薄膜的Zn/O离子比随退火温度的升高而降低,但一直是富锌ZnO,说明未掺杂的富锌ZnO也可以形成p型导电.p型未掺杂富锌ZnO薄膜的形成可归因于VZn受主浓度可以克服VO和Zni本征施主的补偿效应.